LED bulb silicone sealant

INSTRUCTIONS1、Clean surface: cleaning adhesion surface and to remove the rust,dust and greasy dirt, etc.2、After sizing: Unscrew the hose cap (or cutting), squeezing the glue on cleaned surface, so that can be distributed uniformly.3、Curing: the part of bonded or sealed were cured naturally in the air. The curing is a process from the surface to the internal, the depth of curing is 2 ~ 4mm within 24 hours (at room temperature and 55% relative humidity), if the location of sizing is too deep, especially when it is not easy to contact the air, then the completely curing time will be extended, if the temperature is low, the curing time will be extended either, the fully curing time need at least 7 days if the thickness of sealant is 6mm.

Add to Basket

Web address

Other goods of this manufacturer :

LED power modules silicone potting sealant with non-toxic
	Before The CuringPerformance Indicators ABAppearanceGray FluidWhite FluidViscosity 1500～2500(cps)1500～2500(cps)A:B 1:1Mixed Viscosity 1500～2500(cps)Operable Time30～120(min)

low viscosity silicone sealant
	NOTE After operating, the rest of glue must be sealed to store , and tightened the cap immediately. when using it in the next time, if there is a little crust in sealed place, to remove it and it

non-corrosion for materials silicone sealant
	1. Features ZS-NJ-D939C is one kind of the one-component dealcoholized silicone sealant at room temperature curing with medium viscosity. This product has the properti

non-corrosion silicone sealant
	After the curingTensile strength≥1.5（MPa） Elongation At Break≥150(%)Shear strength≥2.0(MPa)Hardness35～45(Shore A) Temperature Range-60～200(℃)Volume resistivity2.2×10

quake-proof silicone sealant for solar power
	1. Features ZS-GF-D906W is one kinds of the one-component alcohol silicone sealant which is room temperature curing. This product is a kind of special sealant for sola

RTV-1 Sealant with excellent thermal conduction
	NOTE After operating, the rest of glue must be sealed to store , and tightened the cap immediately. when using it in the next time, if there is a little crust in sealed place, to remove it and it

silicone gel for power potting
	INSTRUCTIONS1、A, B glue mix according to the weight of the 1:1 ratio，and only after the row of bubble it can be used.In order to improve the bubble velocity,empty after row and bubble in the

silicone gel for power potting
	NOTE There are some materials, such as chemical additives, curing agent and plasticizer can inhibit the curing of our glue.These materials include: •Org