SEMI-AUTO HYDRAULIC WOOD LATHE

1.This machine is suited to manufacture wood pieces below 420 mm (length) , and 130 mm (diamete,r)., 2.The rough pattern knifde seat of this machine is manual operation,but there, are hydraulic drivers for holding material and finishing knife seat., 3.There is one U-shaped knife for the roughing pattern knife seat this machine., You can do the reciprocating cutting beside pattern many times by manual , operations., 4.You can adjust height of the finishing knife seat., 5.Tere is a central needle for wood pieces to find the central point and let it , become convenient for holding ., 6.The man spindle power is 3HP,the pump power is 1HP for oil tank`s is 50L, capacity., 7.The rate for breaking down is very low for this machine because it is manual , and hydraulic operation.,

Add to Basket

Web address

Other goods of this manufacturer :

DING TABLE COLUMN STANDER TURNING LATHE
	This machine is suitable for cutting dinning table column stander which max.,Length is 620mm and the range of the diameter is from max. 300mm to min.100mm. It is also suitable f,or cutting similar la

FULL HYDRAULIC HOPPER FEED BACK KNIFE TURNING LATHE
	Coyer Back Knife Turning Lathe delivers the dependable and rugged service your requite.

FULL HYDRAULIC TURNING LATHE
	THE MACHINE IS ESPECIALLY DESIGNED FOR PROCESSING WOOD ,WITH A LENGTH OF 420mm AND DIAMETER OF 130mm.,THE MACHINE RUNS AUTOMATICALLY AND USES HYDRAULIC POWER ,AS IT`S DRIVING FORCE.,THE MACHINE PERFO

HYDRAULIC COPYING LATHE
	Saves cutter cost ,saves time for production setup,Convenient to use online with a production line or make changes to production.