|
|
General Waterproof Slurry
 Add to Basket
 Web address
Product Name: General Waterproof Slurry
Model Number: NIC-K11
Place of Origin: China
Features and benefits:
1) Can be applied onto damp surface
2) Strong bond strength to substrate of concrete and render. The active
element permeates into capillary pores of the substrate and forms a
compact waterproof layer
3) After the slurry membrane is dried, tile adhesive can be used directly
onto the waterproof layer
4) Can be used either on interior or exterior wall and floor
5) Water resistance and good durability
6) Water vapor permeability
7) Ageing resistance, innocuous, harmless and environment-protected
Application scope:
1) Indoor and outdoor structures, concrete, cement render and brick wall for
waterproofing
2) Irrigation works, machine room, foodstuff storehouse, tunnel, underground
parking, wall, floor, swimming pool, kitchen, toilet and drinkable water pool
Substrate preparation:
1) The substrate must be firm, clean, even and free from grease, oil
2) The obvious pores, sand holes must be plastered with repair mortar, and
sharp edge must be removed
3) If the temperature of the substrate is too high, it should be damp with
water but no obvious water
Instructions:
1) Mixing proportion: 25kg powder: 9kg additive: 0~1kg water
2) Add the additive into the container, then pour the powder agent into
the water slowly; mix them until a lump-free mixture is achieved
3) Use a brush or rolling brush to apply the slurry onto the substrate
and spread evenly
4) The second coat is applied after the first layer is dried and spread
vertically. The third coat is applied when necessary
Normal dosage:
The thickness of the painted film shall be 1.0~1.2mm about 20~25m²/set.
Note:
The above-mentioned dosage is for the case when the substrate is even.
Precautions:
1) Other covering layers can not be done until the waterproof layer is dry
completely
2) The application cannot be conducted below 5°C; do not apply it in the
extremely wet and bad-ventilated surroundings so as to affect the
formation of the waterproof film
3) Do not mix the cured slurry with water and reuse it
4) Do not use it in the place where there are shocks, moving and big cracks
Shelf life:
Unopened products can be stored for up to 12 months in cool dry environment.
Liquid additive can not be stored under temperature lower than 5°C.
Packing:
1) 25kg powder + 9kg additive/set
2) 5kg powder + 1.8kg additive/set
|
help
Add to favorite
Favorite products
Products
