HD -WS01/02 series 10/100M Singlemode Single Fiber Media Converter can convert Optical－Electric Ethernet signals between 10/100M UTP interface (TX) and 100M optical fiber interface (FX). It could extend traditional 10/100M Fast Ethernet to the distance of 90km through single optical fiber link. It possesses stable performance and good quality by adopting latest IC from USA and Taiwan. It must be used in couples，because the transmitted optical differs from the receive optical in wavelength. 6 Group LED indicated lights could fully monitor the working conditions of Converters. It is easy for users to observe network operation. Main features◆The transmission of a channel optical signals can be completed by single fiber. It has doubled in quantity of fiber data transmission compared with twin fiber type. ◆Auto negotiation function allows UTP port to auto select 10M or 100M and Full Duplex or Half Duplex◆The UTP port supports MDI/MDI-X auto crossover.◆Supporting 1600 bytes packet for management.◆Internal circuit of prevented thunder could greatly reduce damage of converters caused by thunderbolt induction.◆Indicator function of link fault (LFP): When optical fiber is at fault, the converter could stop all the link.◆Converter working mode could be chosen: Store and forward switch mode, Modified cut-through switch mode, or Converter mode. Technical Specifications◆Operating standards：IEEE802.3u、10/100Base-TX and 100Base-FX；◆MAC addresses table: 1K◆Data buffer: 128K.◆Connectors: UTP Connector: RJ-45, 10/100Mbps; Fiber Connector: SC, 100Mbps◆Cable:UTP: Cat. 5 UTP cable (the max distance up to100m)Fiber ( Singlemode): 8.3/125, 8.7/125, 9/125, 10/125μm（the max distance up to 90km）◆Flow Control Full Duplex: IEEE802.3x Half Duplex: back pressure◆LED: Power, FX SD, FX Link/Act, TX 100, TX FDX, TX Link/Act.◆Power Requirement: Input :AC 170 ～ 240V or DC -36V-72VOutput:DC 5V.1A◆Time Delay:
It is acceptable for the most 16 sets of different Media Converter Cards within a rack-mountable chassis which is supplied with unified power. Installing at the center of network, it can not only redu
1.Widely used in Fiber to the Home (FTTH) 2.Assembly quickly 3.Operately easy and simpleFast fiber connector is used for field-assembled optical fiber connector, widely used in fiber to the
Features:Applicable for wall-mounted installationEasy to be locked and can open repeatedly by the keyCan be used both indoor and outdoorSuit for SC simplex adaptersCan be used both indoor and outdoorM
Suitable for the installation of fibre units containing between 1 and 12 fibres as well as minicable (24-144 fibres) in 5mm, 7mm, 10mm and 12mm microduct diameters the bundles can contain up to 24 ind
Suitable for the installation of fibre units containing between 1 and 12 fibres as well as minicable (24-144 fibres) in 5mm, 7mm, 10mm and 12mm microduct diameters the bundles can contain up to 24 ind
To keep MicroDuct networks free of debris, seal the system with Push-Fit End Caps. With the same functionality as the Push-Fit Connectors, installation simply involves pushing the MicroDuct into the E
The Push-Fit Reducers make splicing MicroDuct fast and easy. Simply push the MicroDucts into the center of the coupling. No tools are required. The reducers can be connected and disconnected 10 times
Likewise in category "Other Telecommunications Equipment & Accessories":
help
Add to favorite
Favorite products
