|
|
Fire Dragon
Like jet when kick down you gas pedal Installation 1.Check the 12V/DC power cord positive electrode of the distribution board, and connect one of it`s cut ends to white (close to coil), the other cut to yellow. 2.The black is connected with the ground wire. 3.Red is connected with red of the switch, another black of the switch is connected with power ON. 4.Green connects with the positive electrode of the new coil, negative electrode with the ground, in the middle are high-voltage cord and spark plug. 5.The spark plug connects to 10cm from the hole of tailpipe. 6.This product requires to replace exhaust pipe and catalyst.Operation 1.First warm up the car. 2.Pull the turning speed to more than 3500, keep the accelerator, push down the button for 1 to 2 seconds, and then let it go when the exhause pipe gives out flame. 3.Keep the flame for less than 2 seconds, to avoid damage on engine or flame extinguishing.Warning 1.This product is for people with special skills or special professions. 2.It must not be used on roads, public areas or among moving vehicles. 3.Take care not to get close to gas station, electric appliances or liquid fuel material when the flame is one. 4.This product has certain danger. The owner must take full responsibility if causing bad effecton the vehicle or engine
 Add to Basket
 Web address
|
help
Add to favorite
Favorite products
