Address: No. 8, 5th Road, Songpingshan Factory Zone, Hi-Tech Industrial Park, Nanshan, Shenzhen, Guangdong, China (Mainland) Zip: 518057
Phone: +86-755-86161032
3D Laser Engraving Machine
PHANTOM-I is used to produce crystal artwork, and can engrave 2D or 3D pictures in any transparent material except tempered glass.Traditional 3D glass markers use worktable processing, with a maximum frequency of 30Hz (very slow).Our working frequency is up to 1000Hz (very fast). For example, to mark a portrait which is 60,000 points in a crystal, it takes approximately half an hour to process with a traditional machine, but it takes only one minute with the PHANTOM-II. In addition, the PHANTOM-II uses a green laser, the engraved points in the materials are very small and symmetrical so that the machine can make artwork more precisely and the picture can be appreciated clearly from any point of view.The PHANTOM-II is much smaller than the PHANTOM-I (more suitable for use in shopping malls) and is also compatible with a 3D digital camera made by INSPECK from Canada.
Product Name: Laser Cutting MachinePlace of Origin: ChinaFeatures:The cutters of this model have robust functions, combines the bitmap engraving, vectorcutting and laser drilling in one unit. This sys
Product Name: Laser Cutting MachineModel Number: CB1206-100Place of Origin: ChinaFeatures:Started by high-speed servo motor, has slowdown sophisticated belt drive, used fixed cutting table. Go-through
Product Name: Laser Cutting MachineModel Number: CB0906Place of Origin: ChinaThe cutter of this model has robust functions, combines the bitmap engraving, vectorcutting and laser drilling in one unit.
Features:Started by high-speed servo motor, has slowdown sophisticated belt drive, used fixed cutting table. Go-through design on Y direction can cut long article. Except the working table, other comp
Features:1) 150W maximum laser output power2) Gantry movement structure3) pilot laser track4) belt bearing transmitting structure5) Raise and lower the laser head to focus6) Max. cutting speed: 500mm/
ApplicationThis model is suitable for cutting and marking armor plating, plastic, wood, composite materials, and die cutting board.System characteristics:1) Collocate standard high power CO2 laser TK1
Product Name: Laser Engraving MachineModel Number: CO2-S100XPPlace of Origin: ChinaFeatures:Power is controlled by software and can be adjusted. The cost of the process is low with no consuming materi
Product Name: Laser Engraving MachineModel Number: CO2-S100Place of Origin: ChinaFeatures:High laser power. Power is controlled by software and can be adjusted. The cost ofthe process is low with no c
help
Add to favorite
Favorite products
