These different requirements provide higher creep-rupture strength than normally achievable in similar grades without these different requirements. ASTM A213 T91 tubes shall be made by the seamless process and shall be either hot finished or cold finished, as specified. Grade TP347HFG shall be cold finished. Heat treatment shall be done separately and in addition to heating for hot forming. The ferritic alloy and ferritic stainless steels shall be reheated. On the other hand, austenitic stainless steel tubes shall be furnished in the heat-treated condition. Alternatively, immediately after hot forming, while the temperature of the tubes is not less than the minimum solution temperature, tubes may be individually quenched in water or rapidly cooled by other means. Tension test, hardness test, flattening test, and flaring test shall be done to each tube. Also, each tube shall be subjected to the nondestructive electric test or hydrostatic test.
These different requirements provide higher creep-rupture strength than normally achievable in similar grades without these different requirements. ASTM A213 T11 tubes shall be made by the seamless pr
ASME SA213 T22 Grades containing the letter H in their designation have requirements different from those of similar grades not containing the letter H.These different requirements provide higher
These different requirements provide higher creep-rupture strength than normally achievable in similar grades without these different requirements. ASTM A213 T91 tubes shall be made by the seamless pr
ASTM A213 T91 Grades containing the letter H in their designation have requirements different from those of similar grades not containing the letter H.These different requirements provide higher
ASMT A333 Grade 1 seamless and welded pipes shall be treated to control their microstructure. Tensile tests, impact tests, hydrostatic tests, and nondestructive electric tests shall be made in accorda
ASMT A333 Grade 4 seamless and welded pipesASMT A333 Grade 4 seamless and welded pipes shall be treated to control their microstructure. Tensile tests, impact tests, hydrostatic tests, and nondestruct
ASMT A333 Grade 6 seamless pipesThis specification covers seamless and welded steel pipe for low temperature service. The Grade 6 alloy steel involved is similar to AISI 4032 low alloy steel.Seamless
ASTM A335 P11 alloy steel pipeThe different mechanical test requirements for pipes, namely, transverse or longitudinal tension test, flattening test, and hardness or bend test are presented.Both ends
Each length of pipe shall be subjected to the hydrostatic test. Also, each pipe shall be examined by a non-destructive examination method in accordance to the required practices.The range of ASTM A335
помощь**
Добавить в избранное
Отложенные товары
