|
| |
| |
LED bulb silicone sealant
|
|
INSTRUCTIONS1、Clean surface: cleaning adhesion surface and to remove the rust,dust and greasy dirt, etc.2、After sizing: Unscrew the hose cap (or cutting), squeezing the glue on cleaned surface, so
|
|
|
| |
low viscosity silicone sealant
|
|
NOTE After operating, the rest of glue must be sealed to store , and tightened the cap immediately. when using it in the next time, if there is a little crust in sealed place, to remove it and it
|
| |
|
|
non-corrosion silicone sealant
|
|
After the curingTensile strength≥1.5(MPa) Elongation At Break≥150(%)Shear strength≥2.0(MPa)Hardness35~45(Shore A) Temperature Range-60~200(℃)Volume resistivity2.2×10
|
| |
| |
RTV-1 Sealant with excellent thermal conduction
|
|
NOTE After operating, the rest of glue must be sealed to store , and tightened the cap immediately. when using it in the next time, if there is a little crust in sealed place, to remove it and it
|
|